Being on the CorelCAD Learning Curve I am a frequent visitor to the HelpFiles.
Searching for solutions seems to indicate that either my installation of CorelCAD 2013 is defective or that the CorelCAD Help File is not fit for purpose?
In this case the search was for:
change drawing scale
Amongst other entries revealed the following:
[Begin quote]
To set general options:
1. Click Tools > Options (or type Options).
2. In the Options dialog box, click System Options .
3. - or -
4. Type SystemOptions.
2. Expand General to set:
Send crash report automatically: Specifies whether to send a report manually or automatically if the program crashes. Manual sending lets you add a comment about the crash and circumstances when the problem occurred.
Merge Zoom and Pan for Undo: Groups consecutive Zoom and Pan commands as a single action for Undo and Redo commands.
Show Print Configuration Manager on creation of new Sheets: Lets you set up a Print Configuration when you activate a new Sheet.
Show Page Setup dialog box on creation of new Sheets: Lets you set up a PageLayout when you activate a new Sheet.
[End quote]
The option to Send crash report automatically is not available, reference the following ScreenShot. This may not seem like a big deal but when dealing with 4+ crashes per hour [often many more] it becomes so irritating that the Crash Report is simply closed to enable CorelCAD to be reopened:
Other Searches reveal similar situations where the directions cannot be followed. Due to a busy schedule I cannot expend the time and effort necessary to fully report all the problems.